What do you need to hook up subs to a stock radio
Contents:
Stock car stereo systems usually do not pack much punch. To really highlight the bass of your car stereo, you need a setup capable of properly reproducing low frequency notes.
Video of the Day
Adding a subwoofer and amplifier to your existing stereo is a great way to improve the bottom-end output of your system and is one of the most common upgrades performed on a car's audio gear. Choose a subwoofer speaker system and amplifier that fits your car's current system and meets your audio needs. You have two basic options: You can purchase a separate amplifier and speaker or you can purchase a powered subwoofer with a built-in amplifier.
When purchasing either form of amplification, look for an amp that accepts high-level signals.
This allows you to run a high level speaker signal from your stock stereo's powered head unit without any additional wiring. If you purchase an amp without speaker level inputs, you will need to also purchase a line-out converter to alter the output of your stock head unit to a low-level signal to be accepted into standard speaker connections on your amp.
How to Hook Up a Subwoofer System to a Car’s Stock Stereo
Position your amp and speaker in your car. Subwoofers can be large speakers that are usually housed in speaker enclosures installed in the trunk of the car. Your amp could be installed near the speaker in the trunk or under a seat. Posted on Wednesday, November 09, - Posted on Sunday, November 13, - Posted on Thursday, November 17, - Posted on Saturday, November 19, - Posted on Tuesday, November 22, - Posted on Thursday, December 08, - Posted on Wednesday, December 14, - Posted on Thursday, December 15, - Robert Silver Member Username: Run the power wire to your amp.
If you have a stock stereo and you have the remote wire there you want to in twine the remote wire with the power wire before inserting in the power slot for amp. The remote wire tells the amp to turn on. Make sure you always turn off your amp when you leave your car, it will overheat and drain your battery. Turn the gain all the way down, start playing music and turn it up to where you usually listen, where the mids sound good. Tune them gain until the subs sound good. RMS is very important when matching subs and amps, yes not enough power will make subs clip, but also to much power will burn your voice coils by over heating them with too much power.
Subs and amps should be matched as closely as possible for best performance and longevity. I have a Pioneer deck, amp, and kicker, installed to shut off from the battery. The sub cuts on and off at high volume when I use the auxiliary cord to phone.
How to Wire an Amp & Subwoofers Into a Stock Stereo
How do I fix this? That could mean your amp cannot handle the sub. Another important factor to consider is Ohms. If you have a 2 ohm sub and a 4 ohm amp it won't produce enough power to properly power the sub. Not Helpful 2 Helpful The wires are not grounded properly, check to make sure the surface is clean, unpainted metal.
- How to hook up an amp and sub to a stock stereo..
- How to Wire an Amp & Subwoofers Into a Stock Stereo | It Still Works?
- free dating glasgow.
Not Helpful 6 Helpful Not Helpful 5 Helpful What would cause my sub to kick in when radio is on and stop working when I change source to CD? The remote antenna power wire is responsible for the antenna coming out of a car with a retractable antenna. Remove the wire and find the correct remote amp, then turn on wire or ignition wire to the vehicle. Not Helpful 15 Helpful You should be able to connect it to the auxiliary on the back of the stereo unit. Not Helpful 3 Helpful 7. My amp is already installed and I just bought a new sub.
How to Wire an Amp to a Sub and Head Unit: 12 Steps
How do I connect my new sub to my old amp? There should be RCA female plugs on your amp, and on the new sub-box enclosure, there should be another set of RCA plugs or clamps.
- how to tell the guy youre dating your pregnant.
- im dating one guy but i like another.
- best serious dating sites canada.
- How to Hook Up a Subwoofer System to a Car's Stock Stereo - cellotonica.com?
- .
- Can you hook up subs to a stock cd player unit?? - cellotonica.com?
- dating 4 months christmas present.
Just match the positive and negatives. Not Helpful 14 Helpful Remote; connect the REM wire to a fuse that only has power when the car is on. I cannot turn it up any higher than halfway without my amp going into protective mode.
Tips Don't forget to test your rem wire before you assume it works. I have installed an amp and speakers to my factory stereo, the problem I am having now is that every time I shut off my car and turn it back on there is no signal to the back speakers. Include your email address to get a message when this question is answered. Gather your equipment Amp, Subs, Stereo, and wiring. Ground it to a piece of bare metal not painted ; most people unscrew a bolt from a seat attach the wire and screw it on. Where is the best place to hook up a line output converter when adding an amp for a sub?
What would cause this? This could be caused by a bad ground. Run yourself a good wire for ground directly to the chassis. Not Helpful 1 Helpful 3.