Hook up studio monitors to imac
Contents:
Connecting Studio Monitors to iMac
Or just something like the Mackie big knob studio? May 17, 5: May 17, 3: There are numerous choices, depends how much you want to pay, you need to check that its compatible with your Operating system too. User profile for user: I have a iMac, and a pair of Mackie HR's. Question marked as Solved User profile for user: Publishing Speciality level out of ten: Hi Joe, thank you very much for this article. It's very useful and it really helped me set up my studio speakers.
A couple of weeks ago, I bought a set of KRK Rokit 5 monitoring speakers since many review sites this was what made me decide on it http: These studio monitors sounded awful at first but after reading this article and following the suggestions it finally sounds better now. However, the bass still sounds a bit too much, do you have any suggestions on how to fix it? Hi Allan - I think the most likely way a 5" speaker would exhibit too much bass is if it's up against a room boundary wall, floor, or worst of all, corner. If that's the case, that'd be the first thing I'd try, moving them a couple of feet away from walls and floor.
Stupid question: how do i connect studio … - Apple Community
If they were sitting on a resonant object something hollow, for example that could also over-emphasize bass. Of course you'll want to check that no tone controls are boosting the low end unintentionally. Any "Loudness" buttons should be off -- those are intended to compensate for quiet listening levels by strongly boosting bass, but they're notorious for overdoing it, and they should never be switched on for normal-level monitoring.
And I assume you've checked the monitors with various commercial recordings as well as your own mixes.
Hence, you must also know how to connect studio monitors to MAC. Some people often think that connecting a studio monitor to a MAC computer is very. The Mackie HR are so-called "powered speakers". that means you can send a so-called "line level signal" to them. The iMac has an analog.
Hopefully one of these might be a contributing factor to an overly-bassy response, and addressing that will restore a more even balance. The triangle is actually less optimal, it should and 'behind' the head not in front of, no? Thanks for writing this great article!
- brooklyn hook up bars.
- 7 Mistakes To Avoid When Setting Up Studio Monitors : cellotonica.com?
- online dating in quetta.
- Connecting Studio Monitors to iMac | Mac Support?
- Play and stream music from your Mac, iPod, or iPad.
- ?
- 2. Avoid the Walls.
I don't understand the Fig. I don't see how the monitors are positioned differently to do away with those reflections shown in the top portion of the image? I also like how in your diagrams, there is no computer shown. You're right, you can't tell from the picture.. Many monitors have different dispersion characteristics in the horizontal and vertical planes -- so a particular model might have wide horizontal dispersion to allow for a more inclusive listening area, but narrower vertical dispersion to avoid reflections, as pictured.
It sounds like you need to increase the input volume for your vocal mic. On the interface there should be a knob labelled Trim or Gain next to the mic input you're using. With the channel strip in record-ready mode red light flashing turn this up until the meter in that channel maxes out at around -6 dB and then record -- that should be plenty of level for your vocal. In playback the levels for the various channels should be set so that the level in the meter in the Master channel strip also tops out at around -6 to -3 dB from the top.
This whole 60' angle thing is hogwash. That's what is recommended for ideal rooms - basically an anechoic chamber.
Is your studio an anechoic chamber? You can't just apply some theoretically ideal angle and get it right. And no, having your speakers too close won't mess with your stereo field First off, an anechoic chamber is not an "ideal room" -- at least not for listening to or mixing music.. Again, the article doesn't suggest that closely-placed monitors will "mess with your stereo field" -- it suggests that it could mess with an inexperienced mixer's panning decisions.
If "that" means affect panning decisions, then yes, it certainly can with inexperienced mixers. It sounds like you may have your speakers positioned differently than the article recommends and perhaps are sensitive about perceived criticism of that choice?
Apple Footer
I have a home studio with Pressonus front port loaded monitors do I still need to keep off the wall behind the speakers? Information about products not manufactured by Apple, or independent websites not controlled or tested by Apple, is provided without recommendation or endorsement.
Positioning the monitors either too close together or too far apart can mess up your stereo panning decisions. A NonLinear Educating Company. Macs have built-in speakers, but you can also connect a set of headphones or external speakers to your computer. Depending on your budget, the sky is the limit. If you want to digitize your vinyl record, cassette tape collection, or other sound source, you can connect your home stereo to your computer. They receive everything above the point, the sub everything below.
Apple assumes no responsibility with regard to the selection, performance, or use of third-party websites or products. Apple makes no representations regarding third-party website accuracy or reliability. Risks are inherent in the use of the Internet. Contact the vendor for additional information.
Other company and product names may be trademarks of their respective owners. Open Menu Close Menu Apple. Connect your Mac to a iPod, iPad, home stereo, speakers, or musical instruments Learn how to connect to and use Apple devices, third-party audio, and musical instruments with your Mac. Play and stream music from your Mac, iPod, or iPad There are several ways to play music from your Mac: You need to install a driver if: Connect your home stereo to a Mac If you want to digitize your vinyl record, cassette tape collection, or other sound source, you can connect your home stereo to your computer.
To record from your home stereo to your Mac, follow these steps: Attach the RCA connectors to your stereo receiver's auxiliary aux output. This might be called "Record" or "Tape Out" on some receivers. Connect the other end of the cable to the audio input port on your Mac or to your Mac-connected audio interface. Turn on your home stereo.